Wsparcie Rotel
Jesteśmy tu po to, by odpowiedzieć na wszystkie pytania dotyczące produktów i urządzeń Rotel, a także by otworzyć drzwi do świata dźwięku o wysokiej jakości.
The on-screen menu for the these models used a 480i video signal to transmit the menu to the monitor. However, many component video sources such as DVD, HD cable and Satellite provide a higher output resolution such as 480p, 720p or 1080i. If the Rotel on-screen menu attempts to overlay the menu on top of these higher video resolutions, it can either distort the video, or may not display at all depending upon the monitor. The solution to this is to enable the 'Progressive' setting for each component video source that uses a 480p or higher resolution. To allow the menu to be viewable, change the input on the Rotel component to a non-video source such as Tape, or turn off the source component so that the on-screen menu is now displaying on a blank background rather than trying to overlay the menu on top of the video source.
The 'Progressive' setting is located in the 'Other Options' menu of the RSP-1068, RSX-1056, RSX-1057 and RSX-1067, or in the 'Display' menu of the RSP-1098. From this menu, the Progressive setting can be enabled for each component video input on the unit. Once the progressive setting has been enabled, the on-screen menu will appear on a black backdrop.
These models offered component video switching but did not provide an on-screen menu on the component video output. A composite video connection is recommended to view the on-screen menu for setup purposes.
First, it may be helpful to verify that the physical connections between the Rotel component and the monitor are correct and that the monitor is on the correct input. If the component cables are in the right place and you are sure you are on the correct input of the TV, simply power cycle the Rotel component off and on. When the unit first powers up, a "System Status" screen should appear on the TV for a few seconds, then disappear. If this screen appears, the connections are correct. If it does appear, this confirms the connections are correct and you should be able to access the menu by verifying the remote is in the AUD mode by pressing the "AUD" button, followed by pressing the Menu/OSD button on the remote.
These models offer component video switching but do not provide an on-screen menu on the component video output. An HDMI video connection is required to view the on-screen menu for setup purposes.
You need to reinitialize the update by reloading 'My Stuff'. Navigate to 'My Stuff' and key select to reload your choices.
This is normal - the time taken to find and listen to an internet radio station can vary and can take over a minute. This is dependent on lots of different related factors - from issues involving your network to how good the radio service is. In practice the time taken can be as small as 2 seconds.
We do not recommend using a different wireless dongle, but if you do need to reduce the amount of space in the rear of the unit, you can use a short USB extension cable to move the radio closer to the wall. Do not use a cable over 20cm or 8".
The digital audio output of your DVD player is not configured to output dts. To change the mode to allow dts streaming, stop the disc and remove it from the DVD player, then follow the instructions below depending on your DVD player:
Please note that you need a Dolby Digital/DTS processor and amplifier or receiver to enjoy 5.1 surround sound.
If you are not getting audio from the PC-USB input on your Rotel system, here are a few things you can check.
Windows:
Go to Control Panel -> Hardware and Sound -> Manage Audio Devices
Mac:
Go to System Preferences -> Sound
Make sure 'Rotel PC-USB' is selected as the active sound device.
扫一扫以下二维码或者搜索微信公众号即可关注,获取最新鲜的ROTEL资讯!
微信公众号:rotel-hifi